Articles PDF eBook ArticlesPDF.com

Installation Procedure Electronic Vessel Control, Volvo Penta IPS Manual. Auto configuration is the EVC system self-identification. Auto configuration should be performed when the system is started for the first time or after system updates. NOTE! A twin installation requires one auto configuration to each engine. Start with port engine. NOTE! In a twin installation when using both EVC system tachometer and EVC system display, please refer to sec- tion Auto configuration – EVC system display before auto configuration is performed. Turn starter key to position I (ignition on). Twin installation: Start with port engine (starboard engine – ignition off) Enter calibration mode. Push and hold BACK BUTTON and MULTIFUNCTION BUTTON until buzzer signal and LEDs light up. Release buttons

NOTE! The EVC system starts to download software to all tachometers followed by the EVC system displays. When downloading software no information will be presented in the displays and all LEDs are off. If the tachometer has never been used status bars will be shown on the tachometer display. First The “SOFTWARE” status bar will be shown and afterwards the “ICON” status bar Volvo Penta IPS Manual.[Download]